1. Rugged frames to match HP and speed requirements

2. Packing box standard

3. Impellers designed for maximum solids handling

4. Hydraulic inter changeability in all types

1. Regular, bronze or stainless steel fitted impeller.

2. Enclosed, semi-open impellers

3. Dry or wet pit

4. Vertical, horizontal

APPLICATIONS :

• Sewage lift stations and disposal plants - raw or treated unscreened sewage
• Paper mills - paper pulp, screening chips
• Packing Houses - conveyance of by-products and waste
• Slaughter houses - wastes from killing floor, hides, by-products
• Canneries - conveyance of fruits, vegetables, fish, shrimp, oysters, wastes etc.
• Underpass service - storm water
• Industries - slurries, slip, mash, wastes

Flowmore, the leader in the construction of Non-Clog pumping equipment, through the impetus of progressive research and design, factory and laboratory, have developed the Flowmore Non-Clog sewage and trash pump-famous- for its sturdy construction and lasting efficiency.

Flowmore will assist in the selection of the equipment best suited for the work, whether it involves the pumping of unscreened sewage. Storm water, industrial waste, beet pulp, food solids, paper pulp, or any of numerous other materials.

Standard pumps both horizontal & vertical are built in sizes varying from 50 to 750 mm. Vertical pumps could be furnished for either wet or dry pit installation. Pumps can also be manufactured in other materials like bronze, aluminum etc. Capacities upto 2,40,000 LPM, Heads upto 85 meters.

Heavy-duty ball-bearings... removable , back-head and suction elbow are but few of the many outstanding features. Inspection-holes with cover-plates are standard on pump volutes in sizes 75 mm and larger.

SHAFT : Turned and ground to accurate dimensions from high-grade alloy-steel and furnished with special shaft sleeve through the stuffing-box.

STUFFING BOX : These pumps are furnished with cartridge type stuffing box which permits the use of glands.

IMPELLER : The impeller is enclosed non-clog 2-vane type cast in one piece and specifically designed to pass large solids or unscreened liquids. Clearance between the rotating and stationary parts is adjustable to provide sustained performance without excessive maintenance.

This pump may also be furnished with the famous Flowmore bladeless impeller which has been proven capable of passing unscreened liquids containing solids upto 25-times the size a conventional pump will handle.

FRAME : The rotating assembly is supported on heavy-duty ball-bearings mounted in a precision bored frame. Bearings are carefully sealed to exclude moisture and contaminants, the retain lubricant. Provision is made for lubrication or periodic cleaning without disassembly. Frame is of special construction assuring the ultimate in alignment and rigidity with proper supports for the rotating parts of the pump. Several frame sizes are available with each liquid end to match the rating of the driving motor.

BASE : ( for Vertical Pumps ) the entire pump is supported by a rugged base with reinforced and machined lugs for belting to the foundation and with machined surfaces to assure a rigid and attractive appearing installation.

SUCTION ELBOW : Suction elbow is available either as a constant diameter elbow or increaser elbow as specified. All suction elbows are provided with bolted inspection covers, the interior contour of which conform to the inside of the elbow. These inspection covers permit access to the impeller inlet or to the run of pipe immediately preceding the pump suction.